Rainbow Electronics MG260 - Manual (Page 220)

FLYFOT-MG260-MODULE
Page: 220 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Or 129 bytes (version V1)
Timing Advance 1 byte
Date and Time 7 bytes : Date, time and timezone at
STLK Format
for mode = 3 :
optional parameter
Range : [1-255] (at least 1 bit set to 1).
if bit 0 set to 1 (value 1) : DaT will be returned in the response
if bit 1 set to 1 (value 2) : TA will be returned in the response
if bit 2 set to 1 (value 4) : BCCH will be returned in the response
if bit 3 set to 1 (value 8) : NetMeas will be returned in the response
if bit 4 set to 1 (value 16) : CI will be returned in the response
if bit 5 set to 1 (value 32) : LAC will be returned in the response
if bit 6 set to 1 (value 64) : MNC-MCC will be returned in the response
Notes :
z After having downloaded the EEPROM configuration: default value of is 0xFF (all
information returned).
z The value set with the command “at+wloc=3,xx” is saved in EEPROM, so it will be
taken into account after an Init.
Fields of the response to AT+WLOC? :
The response is built as follows
+WLOC: ,,
:
0 : no automatic mode
1 : automatic mode
, :see above.
18.45 FLYFOT Bus Read +WBR
Description
This specific command allows to read a buffer from a specific bus (SPI, I2C Soft or Parallel).
Note : Bus configuration is set by the +WBM command.
Syntax
Command syntax : AT+WBR=,[,