Rainbow Electronics MG260 - Manual (Page 207)

FLYFOT-MG260-MODULE
Page: 207 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Note :
When the parameter is changed, the product must be reset to
take the modification into account.
18.34 Unsolicited result : FLYFOT Battery Charge Indication +WBCI
Description
This unsolicited indication returns information about the battery charge (maximum level
reached, current battery voltage).
Syntax
Unsolicited response syntax : +WBCI: [,]
Defined values
0 : Minimum battery level reached. The battery is considered as discharged.
The product is turned off (as with the +CPOF command).
1 : Maximum battery level reached. The battery is considered as charged.
The battery charging is stopped.
2 : Battery currently in charge.
3 : Battery currently out of charge.
: Current battery voltage during or out of the charging.
The possible range is [2800 ; 5000]. (in mV)
Note :
= 2 and 3 are solicited, by the AT+WBCM=2 command, or unsolicited when the
parameter of the +WBCM command is set to 1. With these values, the parameter is
also present.
18.35 Features Management +WFM
Description
This specific command allows some features to be enabled or disabled.
Note :
After a modification, the changes will be taken into account only after a reset of the product.
Syntax
Command syntax AT+WFM=[,]