Rainbow Electronics MG260 User Manual
Page 26
FLYFOT-MG260-MODULE
Page: 26 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
Defined values :
Operation:
0:turn off the led
1:flash the led according to the other parameters
light time in idle:
0~65535 the light time in idle state;
dark time in idle:
0~65535 the dark time in idle state;
light in calling:
0~65535 the light time in calling state;
dark in calling:
0~65535 the dark time in calling state;
mode:
0:Normal mode
1:Super mode(the flash of the led is not relative to the calling of registeration state)
4.23 Restricted SIM access +CRSM
Description
By using this command instead of Generic SIM Access +CSIM TE application has easier but more
limited access to the SIM database. This command transmits to the MT the SIM
required parameters.
As response to the command, MT sends the actual SIM information parameters and response data. MT
error result code +CME ERROR may be returned when the command cannot be passed to the SIM,
but failure in the execution of the command in the SIM is reported in
parameters.
As for the CSIM command , there is no locking between two successive commands. The user should
be aware of the precedence of the GSM application commands to the TE commands.
Syntax
Command
Possible responses
+CRSM=
[,
+CRSM:
+CME ERROR:
AT+CRSM?
OK
AT+CRSM=?
OK
Defined values
Command passed on by the MT to the SIM; refer GSM 11.11 (or 3GPP TS 51.011) :
176 READ BINARY
178 READ RECORD
192 GET RESPONSE
242 STATUS
all other values are reserved and the command will return +CME ERROR=3