Rainbow Electronics MG260 - Manual (Page 223)

FLYFOT-MG260-MODULE
Page: 223 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
AT+WBM=,,[],[],
[],[],[],
[],[]
z Command Syntax for I2C bus
AT+WBM=,,[],[]
z Command Syntax for parallel
The parameters depend on ChipSelect configuration :
if CS is Gpio 5 :
AT+WBM=,,[],[],[]
if CS is LCD_EN
AT+WBM=,,[],[],
[],
[],
[]
Command Possible responses
AT+WBM=0,1,1,3,1,0,1 OK
Open SPI bus with configuration :
Clock Speed : 812 kHz
Clock Mode : 3
ChipSelect : LCDEN
ChipSelectPolarity : LOW
LsbFirst : MSB
AT+WBM=1,1,0,4 OK
Open I2C Soft bus with configuration :
Scl Gpio : 0
Sda Gpio : 4
AT+WBM=2,1,0,1,10, 31,0
Open PARALLEL bus with configuration :
(on P32X3 product)
ChipSelect : LCDEN
Order: Direct
LcdenAddressSetUpTime: 10
LcdenSignalPulseDuration : 31
PolarityControl : low OK
AT+WBM=0,2 +WBM: 0,1,1,3,1,0,1,0,0
OK
AT+WBM=1,0 OK