Rainbow Electronics MG260 - Manual (Page 175)

FLYFOT-MG260-MODULE
Page: 175 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
: Keyboard map is (5,5)
0 1 2 3 4
5 6 7 8 9
10 11 12 13 14
15 16 17 18 19
20 21 22 23 24
1: key press
0: key release
: indicator order number (as specified for +CIND)
: new value of the indicator
18.4 Indicator control +CIND
Description :
This command is used to set the values of ME indicators. If ME does not allow setting of indicators or ME
is not currently reachable, an error code is returned.
Syntax :
Command Syntax: AT+CIND=[[,[,…]]]
Response syntax : +CIND: [,[,…]]
Command
Possible responses
AT+CIND=[[,[,…]]]
+CME ERROR:
Note : ME not reachable
AT+CIND=[[,[,…]]] OK
AT+CIND?
Note: read ME indicators current values +CIND: [,[,…]]
OK
AT+CIND=?
Note: read possible value for ME indicators
+CIND:
("battchg",(0-5)),("signal",(0-5)),("service",(0-
1)),("message",(0-1)),("call",(0-1)),("roam",(0
-1)),("smsfull",(0-1))
OK
Defined values :
:
0: indicator is OFF or in state which can be identified as “OFF” state
1: indicator is ON or in a state that is more substantial than “OFF” state