Rainbow Electronics MG260 - Manual (Page 127)

FLYFOT-MG260-MODULE
Page: 127 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
s), (list of supported s), (list of
supported s) , (list of supported s),
(list of supported
s) [+CGQREQ: , (list
of supported s), (list of supported
s), (list of supported s) , (list of
supported s), (list of supported s)
[…]]
OK
AT +CGQREQ=1,1,4,5,2,14 OK
AT+CGQREQ=? +CGQREG:“IP”,(1-3),(1-4),(1-5),(1-9),(1-31)
+CGQREQ:“PPP”,(1-3),(1-4),(1-5),(1-9),(1-31)
OK
AT+CGQREQ?
+CGQREQ: 1,1,4,5,2,14
+CGQREQ: 3,3,7,7,15,255
OK
Defined values
: numeric parameter which specifies a particular PDP context definition. Range of values is 1 to 3
: numeric parameter which specifies the precedence class
0 : Subscribed precedence (Subscribed by the Network by default if value is omitted)
1 : High priority (Service commitments shall be maintained ahead of precedence classes 2 and 3)
2 : Normal priority (Service commitments shall be maintained ahead of precedence class 3.)
3 : Low priority (Service commitments shall be maintained after
precedence classes 1 and 2)
: numeric parameter which specifies the delay class
0 : Subscribed
1 : Delay class 1
2 : Delay class 2
3 : Delay class 3
4 : Delay class 4
Delay (maximum values)
SDU size: 128 bytes SDU size: 1024 bytes
Delay Class
Mean
Transfer
Delay (sec) 95
percentile
Delay
(sec) Mean
Transfer
Delay
(sec) 95 percentile Delay (sec)