Rainbow Electronics MG260 - Manual (Page 102)

FLYFOT-MG260-MODULE
Page: 102 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
0: unconditional call forwarding is active
1: some of the conditional call forwarding are active
2: call has been forwarded
3: call is waiting
4: this is a CUG call (also present)
5: outgoing calls are barred
6: incoming calls are barred
7: CLIR suppression rejected
1: closed User Group call, with CUG
2: call has been put on hold (during a voice call, & fields may be present)
3: all has been retrieved (during a voice call, & fields may be present)
4: multiparty call entered (during a voice call, & fields may be present)
5: call on hold has been released (during a voice call)
7: call is being connected (alerting) with the remote party in alerting state in Explicit Call Transfer
operation (during a voice call)
8: call has been connected with the other remote party in Explicit Call Transfer operation (during a voice
call, & fields may be present)
Closed User Group index
<number>
String type phone number
Type of address
10.11 Unstructured supplementary service data +CUSD
Description:
The USSD supplementary service is described in GSM 02.90.
It is based on sequences of digits, which may be entered by a mobile user with a handset. A sequence
entered is sent to the network which replies with an alphanumerical string, for display only, or for display
plus request for the next sequence.
This command is used to:
z Enable or disable the CUSD indication sent to the application by the product when an incoming
USSD is received
z Send and receive USSD strings
Syntax:
Command syntax: AT+CUSD = [, []]
Note: in case of enabled presentation, a +CUSD (as direct answer to a send USSD) is then indicated with:
+CUSD: [, , ]