Rainbow Electronics MG260 - Manual (Page 109)

FLYFOT-MG260-MODULE
Page: 109 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
9: a ‘Send SMS’ pro-active command has been sent from the SIM. (*)
10: a ‘Send USSD’ pro-active command has been sent from the SIM. (*)
11: a ‘SETUP EVENT LIST’ pro-active command has been sent from the SIM.
98: timeout when no response from user.
99: a “End Session” has been sent from the SIM.
(*) if the automatic response parameter is activated, this indication is followed by the corresponding
+STGI response.
12.4.1.2 Last SIM toolkit indication
The last SIM toolkit indication sent by the SIM can be requested by the AT+STIN? command. This
command is only usable between the sending of the STIN indication by the SIM (step 2: see section 16.2)
and the response of the user with the +STGI command (step 3).
Command syntax: +STIN?
Command Possible responses
+STIN?
Note : Ask for the last SIM toolkit indication sent by
the SIM +STIN: 0
OK
Note : the last SIM toolkit indication was a Setup
Menu
+STGI=0
Note : Display the SIM toolkit application menu
+STIN?
Note : Ask for the last SIM toolkit indication sent by
the SIM +CME ERROR: 4
Note : operation not supported, the
+STGI command has been already used
12.5 SIM ToolKit Get Information (+STGI)
Description
This command allows to get the information (text to display, Menu information, priorities…)
of a pro-active command sent from the SIM.
The information is returned only after receiving a SIM Toolkit indication (+STIN).
Syntax
12.5.1.1 Command syntax : +STGI=
Command Possible responses
+STGI=
See Table 1
+CME ERROR:
+STIN: index
+STGI=?
+STGI: (0-11)
OK