Rainbow Electronics MG260 - Manual (Page 83)

FLYFOT-MG260-MODULE
Page: 83 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Defined values :
See above descriptions
9.14 Message status modification +WMSC
Description
This commands allow the manipulation of a message status. The accepted status changes are from READ
to NOT READ and vice versa, and from SENT to NOT SENT and vice versa.
NOTE:
At present, the product only support the status change from NOT READ to READ.
Syntax:
Command syntax : AT+WMSC= ,
Command
Possible responses
AT+WMSC=25,1 OK
Note: the status change from NOT READ to
READ.
AT+WMSC=51,1 +CMS ERROR: 321
Note: If is invalid or free
AT+WMSC=10,1 +CMS ERROR: 302
Note: If the new and the previous one
are incompatible.
AT+WMSC
AT+WMSC?
AT+WMSC=? +CMS ERROR: 3
Note: not supported.
Note:
If all the parameters are correct, the product overwrites the whole SMS in SIM. Only the first byte (Status
byte) is changed.
Defined values:
location number of the stored message (integer)
new status to be stored, as for +CMGR command :
9.15 Message overwriting +WMGO
Description:
The WMGO command is used to specify a location in the SIM, for the next