Rainbow Electronics MG260 - Manual (Page 208)

FLYFOT-MG260-MODULE
Page: 208 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Response syntax +WFM: ,,
Command Possible responses
AT+WFM=2,”BI9001800” +WFM: “BI9001800”,1,0
OK
Note : Dual-band mode 900/1800 is enabled
AT+WFM=1,11 +CME ERROR: 3
Note : Enable the Mono-band 900 Note : Band selection are not allowed
mode with AT+WFM command
AT+WFM=0,61 +CME ERROR: 3
Note : =0 is not allowed on
values with2 digits
AT+WFM=0,”EFR” OK
Note : Disable the Enhanced Full Rate
feature
Defined values
0 : disable feature
1 : enable feature
2 : interrogate the status of the feature.
If theparameter is not used, the status of all the features are listed (with several +WFM
responses).
Numeric value String value Meaning
11 "MONO900" Mono-band mode 900 MHz (def. 0)
12 "MONO1800" Mono-band mode 1800 MHz (def. 0)
13 "MONO1900" Mono-band mode 1900 MHz (def. 0)
14 "BI9001800" Dual-band mode 900/1800 MHz (def. 1)
15 "BI9001900" Dual-band mode 900/1900 MHz (def. 0)
16 "MONO850" Mono-band mode 850 MHz (def. 0)
17 "BI8501900" Dual-band mode 850/1900 MHz (def. 0)
18 "QUADBAND" Quad-band mode 850/900/1800/1900 MHz
2 "EFR": Enhanced Full Rate feature (def. 1)
31 “NOHR_NOECHO” HR and ECHO features are disabled
32 "HR" Half Rate feature (def. 1)
33 "ECHO" Echo Cancel (def. 0)
4 "DTXDATA" Data with DTX feature (def. 1)
5 "DATA144" Data 14.4 kbit/s feature (def. 1)
61 "SIM3VONLY" 3V SIM voltage mode (def. 0)