Rainbow Electronics MG260 User Manual
Page 170
FLYFOT-MG260-MODULE
Page: 170 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
18 Specific AT commands
18.1 General Indications +WIND
Description :
FLYFOT has introduced a general mechanism to send unsolicited non-standardized indications
to the application. These indications are:
z
indication of a physical change on the SIM detect pin from the connector (meaning SIM inserted,
SIM removed)
z
indication during mobile originated call setup that the calling party is ringing.
z
Indication of the availability of the product to receive AT commands after boot.
For each indication, a “bit flow” has to be indicated.
Syntax:
Command syntax: AT+WIND=
Command
Possible responses
AT+WIND?
+WIND: 0OK
AT+WIND=255
OK
Note: The SIM has been removed
+WIND: 0
Note: The SIM presence pin has been detected
as “SIM removed”
Note: The SIM has been inserted
+WIND: 1
Note: The SIM presence pin has been detected
as “SIM inserted”
Note: The network service is available for an
emergency call
+WIND: 7
Note: The initialization has been completed
+WIND: 4
The AT+WIND? command is supported and indicates the
AT+WIND settings are automatically stored in non volatile memory (EEPROM).
This means the &W command does not need to be used and the selected
flows are always activated after boot.
Default value is 0: no flow activated, no indication.
AT+WIND=? gives the possible value range (0-4095)
The unsolicited response will then be:
+WIND :
Or for event 10: