Rainbow Electronics MG260 - Manual (Page 180)

FLYFOT-MG260-MODULE
Page: 180 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
0: I/O port number is reset.
1: I/O port number is set.
18.9 Write GPIO value +WIOW
Description
Set the requested GPO or GPIO pin value.
Note :
z by default (after a reset), the I/O ports configuration is set by the +WIOM command.
z This command is allowed only on a GPIO not allocated by the Open-AT embedded application
or for bus operations.
Syntax
Command syntax: AT+WIOW=,
Defined values
Eight I/O ports are available. The value is between 0 and 7.
0: I/O port number is reset.
1: I/O port number is set.
18.10 Input/Output Management +WIOM
Description
This specific command allows to set the default GPIOs configuration (input or output) after reset, and
each GPIO default value (if set as an output) after reset.
Note :
z This command is allowed only on a GPIO not allocated by the Open-AT embedded
application or for bus operations.
Syntax
Command Syntax AT+WIOM=[],[]
Command
Possible responses
AT+WIOM? +WIOM: 255,0