Rainbow Electronics ATmega163L - Manual (Page 85)

ATmega163(L)
85
Figure 55. Formats and States in the Slave Transmitter Mode
Assembly Code Example - Slave Transmitter Mode
; Part specific include file and TWI include file must be included.
;
ldi r16, (1<
out TWCR, r16 ; Enable TWI in Slave Transmitter Mode
;
wait14: in r16,TWCR ; Wait for TWINT flag set. This indicates that
sbrs r16, TWINT ; SLA+R has been received, and ACK/NACK has
rjmp wait14 ; been returned
in r16, TWSR ; Check value of TWI Status Register. If status
cpi r16, ST_SLA_ACK ; different from ST_SLA_ACK, go to ERROR
brne ERROR
ldi r16, 0x33 ; Load data (here, data = 0x33) into TWDR register
out TWDR, r16
ldi r16, (1<
out TWCR, r16 ; Clear TWINT bit in TWCR to start transmission of data.
; Setting TWEA indicates that ACK
; should be received when transfer finished
;
wait15: in r16,TWCR ; Wait for TWINT flag set. This indicates that
sbrs r16, TWINT ; data has been transmitted, and ACK/NACK has
rjmp wait15 ; been received
S SLA R A DATA A
$A8 $B8
A
$B0
Reception of the own
slave address and one or
more data bytes
Last data byte transmitted.
Switched to not addressed
slave (TWEA = '0')
Arbitration lost as master
and addressed as slave
n
From master to slave
From slave to master
Any number of data bytes
and their associated acknowledge bits
This number (contained in TWSR) corresponds
to a defined state of the 2-Wire Serial Bus
P or S DATA
$C0
DATA A
A
$C8
P or S All 1's
A