Ohaus Voyager Balances - Manual (Page 56)

50
RS232 COMMAND TABLE (Cont.)
5.2 RS232 Interface ( Cont.)
P P P P P Print display data
T T T T T Same effect as pressing O/T button.
V V V V V Print EPROM version
Esc V Esc V Esc V Esc V Esc V Print balance ID (13 characters).
xZ xZ xZ xZ xZ Set Auto Zero to “x”,where x = 0 to 3 ). 0=Off, 1=0.5d, 2=1d, 3=5d.If LFT,
programs Auto zero level from 0 to 1.
Esc R Esc R Esc R Esc R Esc R Resets Setup and Print menus to factory defaults.
CAUTION: This will reset RS232 configuration.
ON ON ON ON ON Turns balance on.
OFF OFF OFF OFF OFF Turns balance off.
? ? ? ? ? Print current weigh mode.
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
xD xD xD xD xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
F F F F F Print current function.
x x x x x IIIII Set Averaging Filter Level to “x”,
where x = 0 to 9 (see table).
If LFT, level 0 to 2.
xM xM xM xM xM Places balance in mode “x”,
where x = 1 to 17 (see table).
If unit or mode is not already
enabled, command will be ignored.
1 = milligrams
2 = grams
3 = kilo grams
4 = dwt
5 = Carats
6 = Ounces
7 = Ounces troy
8 = Grains
9 = Taels Hong Kong
10 = Taels Singapore
11 = Taels Taiwan
12 = Mommes
13 = Decimal Pounds
14 = Pounds-Ounces
combined
15 = Newton's
16 = tical
17 = Custom Units
0 = minimum level
1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
9 = maximum level