Ohaus Voyager Balances - Manual (Page 255)

14
Installation
2.7 Switching the balance on and off
Your balance is on at all times when connected to a power source, the display is on initially and can be turned
off.
To switch the balance on, press the button. As soon as the weight
display appears, your balance is ready.
To switch the balance off, press the
button. After the balance has been
switched off, your balance is in the standby mode. If you wish to perform a
weighing, press the
button again.
As your balance needs no warm-up time when in the standby mode and
is immediately ready for weighing, we advise you to switch the display off
by use of the
button and not to disconnect it from the power supply.
This also ensures that the balance is always in thermal equilibrium.
0.000
BASIC WEIGHING
2.8 Weigh below preparation
The Voyager balance is equipped with a weigh below hook at the bottom of the balance. To use this feature, remove
power from the balance and remove the protective cover underneath the balance. See illustration for location. The
balance can be supported using lab jacks or any other convenient method. Make sure the balance is level and
secure. Apply power and operate the balance. Attach items to be weighed to the hook underneath the balance.
BOTTOM OF BALANCE
WEIGH BELOW
HOOK LOCATION
REMOVE
PROTECTIVE
COVER.
WEIGH BELOW
HOOK IS INSIDE OF
BALANCE.