Ohaus Voyager Balances - Manual (Page 140)

76
8.2 Printing data
Printing data to an external computer or printer requires that the communications parameters be set first.
Printing to an external printer or computer will occur each time the Print button is pressed unless the autoprint feature
is turned on, in which case, printing can occur in a continuous fashion at specified intervals or each time a stable
reading is achieved. When an external printer or computer is properly connected and the communication parameters
are set correctly, the display indicates PRINTING... If the external printer or computer is improperly connected or the
communication parameters are set incorrectly, PRINT FAILED is displayed. To clear the screen, press the Go back
button. Check computer/printer settings and connections.
This section defines the various printing setups with printing samples.
The sample shown, indicates the status in the menus.
Time and date
When time and date are entered in the balance with both Time and Date
options set to ON, each printout starts with the date and time on the first line.
TYPE= MM/DD/YY
TYPE= 24 HOUR
12/01/99 16:00:00
READOUT
STABILITY LEVEL FILTER = 0.5d
AVERAGING LEVEL FILTER = 1
AZT LEVEL = 0.5d
GLP PRINT OPTIONS
DATE & TIME = OFF
BALANCE ID = OFF
PROJECT NAME = OFF
USER NAME = OFF
DIFFERENCE = OFF
PRINT OPTION
AUTO PRINT = OFF
INTERVAL= 0
STABLE PRINT = OFF
NUMERIC DATA = OFF
DATE= OFF
TIME= OFF
PRINT REFERENCE = OFF
RS232 = 2400: NONE: 7 : 2
SAMPLE PRINTOUTS
RS232 Interface/printing data