Ohaus Voyager Balances - Manual (Page 273)

32
Balance modes
6.1.2 Advanced counting
Advanced Count contains a number of entries which include assigning a library name, filling and sorting applications
and statistical information which can be printed. Once a library name is assigned, this particular counting function
can be recalled at any time.
PARTS COUNTING
ADVANCED PARTS COUNTING
PART COUNTING SETUP
LIBRARY NAME
Enter
Function link
Four options are available, OFF, FILLING, CHECK WEIGHING and STATISTICS.
When FILLING is selected, a target weight is entered which is shown as
100% on the bar graph on the display. When material is added to the
balance pan, it is displayed as a percentage and weight. When CHECK
WEIGHING is selected, a separate display has entries for nominal pieces,
over pieces, under pieces, run and exit. This type of function permits check-
ing of individual pieces against the stored information in the balance. When
STATISTICS is selected, provides display of Standard Deviation, either popu-
lation or sample, Mean, Sum, High, Low and Difference readings. Each can
be individually set ON or OFF. RUN when selected starts the program.
Library name
Enter library name, up to 8 characters and press Enter button. The library
name can be recalled later and the same type of items can be counted at
any time. The display advances to APW/SIZE.
APW/SIZE
APW/Size
Enter APW/SIZE. You have a choice of entering a sample size or average
piece weight. Enter required data. Display advances to TARE WEIGHT.
PART COUNTING SETUP
TARE WEIGHT
Tare weight
Enter the tare weight. This is the tare weight of the container holding the
samples.
PARTS COUNTING SETUP or
AUTO OPTIMIZATION ON
Auto optimization
An ON or OFF function. When set ON, optimizes the accuracy based on
sample size. After selecting, the display advances to FUNCTION LINK.
FUNCTION LINK
OFF
FILLING
CHECK WEIGHING
STATISTICS
PARTS COUNTING SETUP
APW/SIZE
TARE WT
AUTO OPTIMIZATION
FUNCTION LINK
RUN
From main menu
Enter CHANGE MODE. Select PARTS COUNTING and then select ADVANCED
PARTS COUNTING. Display advances to PARTS COUNTING SETUP with
LIBRARY NAME highlighted.
Enter
SAMPLE SIZE
SET A.P.W.