Ohaus Voyager Balances - Manual (Page 228)

75
RS232 Interface/printing data
RS232 COMMAND TABLE (Cont.)
T Same effect as pressing O/T button.
V Print EPROM version
Esc V Print balance ID (13 characters).
xZ Set Auto Zero to “x”,where x = 0 to 3 ). 0=Off, 1=0.5d, 2=1d, 3=5d.If LFT,
programs Auto zero level from 0 to 1.
Esc R Resets Setup and Print menus to factory defaults.
CAUTION: This will reset RS232 configuration.
ON Turns balance on.
OFF Turns balance off.
? Print current weigh mode.
# Print current Parts Count Reference Weigh.
% Print current Percent Reference Weigh.
xA Set Auto Print feature, action CA - continuous printing, SA - print on stability, 0A -
turns all selections off.
ID Print Current ID String.
XID Program User ID String, 1-8 characters.
SN Show Serial Number.
xS Print Stable Only. Where x =0 Off and x=1 On.
TIME Print Current Time. Note, a ? mark will follow if date or time has not been set.
SETDATE Set Date Command and remove Invalid Indicator
SETTIME Set Time Command and Remove Invalid Time Indicator
DATE Prints Current Date. Note, a ? mark will follow the year if date or time has not been
set.
Command
Character Description