Xerox MAX 200 - Manual (Page 42)

40 MAX 200 power
Switching the power-on (continued)
4. Switch the printer power-on.
The switch is located above the door.
5. Position the scanner circuit breaker switch to the on
position (up).
The scanner circuit breaker is located at the lower
rear right corner.
6. Switch the scanner power-on.
Switching the power off
WARNING: The machine power switch does not break power to
the low voltage power supply, to remove power from the
machine disconnect the power cord.
Note: This procedure is for the printer and scanner only. If your
system contains the folder or stacker, refer to their user guide for
power-off instructions.
1. Switch the scanner power off.
The printer power is automatically switched to the off
position.