Xerox MAX 200 - Manual (Page 186)

184 How to customize the MAX 200
How to change the system features (continued)
Plotter setup (continued)
Set default time to plot (continued)
5. Select set default time to plot.
The set default time to plot mode screen is displayed.
6. Select the desire time; 10 seconds, 1, 3, 5, 10, 20 minutes.
7. Select done to store your changes and to exit from the current
screen.
To cancel the changes and exit from this screen, select cancel.
8. To exit, press the custom presets button.
10 seconds
Set Default Time to Plot
Mode Cancel Done
Custom Presets
1 minute 3 minutes 5 minutes
10 minutes 20 minute
Select time to switch from copy mode to plotter after
completing a copy job
Set Default
Time to Plot
Set Delay
Time to Copy
Folder
30 seconds Delay Set
3 Minutes No Fold
Plotter Setup Cancel Done
Custom Presets