Xerox MAX 200 - Manual (Page 194)

192 How to customize the MAX 200
How to change the system features (continued)
Additional setting
Introduction
The additional setting feature provides additional system default
settings, for future needs.
Depending on the code entered, the MAX 200 allows you to further
customize your machine. If needed, service will provide you with the
additional setting code and field value.
The identified additional settings codes are:
•
Automatic switching from roll to tray (copy mode), code 10.
•
Automatic switching from roll to tray (plot mode), code 11.
•
Trail edge starting point of stamp location, code 110.
•
Enable synchronize cut in auto mode, code 200.
•
Default cut mode for auto mode, when manual mode cut
default is set to long copy, code 210.
For detailed information about the identified codes, refer to page 169.
Procedure
1. Enter custom presets. If needed, refer to page 174.
2. Select the system features tab.
3. Use the arrow buttons to select the additional setting feature.
4. Select open.
The additional setting (system feature) screen is displayed.
Press Custom Presets to return to
Previous screen.
System features Copy features Storage/Disk
Manager
Open
Time & Date
Auto Power Off
Auto Power save
Auto Clear/ Backlight Off
Attention Tone
Plotter Setup
Loading Stamp Data
Additional setting