Xerox MAX 200 - Manual (Page 29)

Getting to know the MAX 200 27
Scanner control panel (continued)
Stop copy button
Introduction
When the stop copy button is pressed, the printer stops printing. If
the button is pressed during the copy cycle, the printer stops after
completing the current copy cycle. You are given the option to
continue the copy process or delete the image.
Procedure
1. Press the stop copy button.
The stop copy screen is displayed.
2. Select yes to resume the same copy job (at the point where it
was stopped) or select no to cancel the current job.
Interrupt button
Introduction
Press the interrupt button when you need to run a job other than
the current job that is printing and would like to return to the original
print job without setting up the original job again.
Procedure
1. Press the interrupt button.
When the current copy cycle is complete the ready to copy
message is displayed. The interrupt indicator lamp stops
flashing when the printer is ready to be programmed for the
interrupt job.
2. Select the desired features and run the different job.
3. To return to the original job, press the interrupt button.