Xerox MAX 200 - Manual (Page 220)

218 How to customize the MAX 200
How to change the copy features (continued)
Variable length default
Note: When the set variable length is longer than the original length,
the excess is output blank.
Introduction
The variable length default feature sets up the default cut length for
each roll, for the variable length option, located on page 85.
Procedure
1. Enter custom presets. If needed, refer to page 174.
2. Select the copy features tab.
3. Use the arrow buttons to select the variable length default
feature.
4. Select open.
The variable length default screen is displayed.
Press [Custom Presets] to return to
Previous screen.
Media Type and Width for Auto Mode
Stamp Location and Orientation
Date Stamp Format
Folder Setup
Auto/ Manual Mode
Media Cut Mode and Document
Orientation
Lead/Trail Edge Default Synchro
Variable length default
System features Copy features Storage/Disk
Manager
Open