Xerox MAX 200 - Manual (Page 185)

How to customize the MAX 200 183
How to change the system features (continued)
Plotter setup
Introduction
The plotter setup allows access to the plotter setup features. There
are three setup features available:
Feature Function
Set default time to plot Sets up the time delay from copy mode
to plot mode. Refer to page 183.
Set delay time to copy
mode Sets up the time delay it takes from plot
mode to copy mode. Refer to page 185.
Folder Sets up the fold default for plot mode.
Refer to page 187.
Set default time to plot
Procedure
1. Enter custom presets. If needed, refer to page 174.
2. Select the system features tab.
3. Use the arrows to select the plotter setup feature.
4. Select open.
The plotter setup screen is displayed.
Press Custom Presets to return to
Previous screen.
System features Copy features
Storage/Disk
Manager
Open
Time &Date
Auto Power Off
Auto Power save
Auto Clear/ Backlight Off
Attention Tone
Plotter Setup
Loading Stamp Data