Xerox MAX 200 - Manual (Page 181)

How to customize the MAX 200 179
How to change the system features (continued)
Auto clear/backlight off
Introduction
After a job is completed, the auto clear feature resets the job
settings to the default values. To meet your requirements, change
the time it takes for the machine to reset the default values.
The backlight feature sets the period of time for the touch screen
backlight to turn off, after a job is complete. You set the default time
period.
If both auto clear and backlight are set to yes, then each feature
occurs at the same time.
Procedure
1. Enter custom presets. If needed, refer to page 174.
2. Select the system features tab.
3. Use the arrow buttons to select the auto clear/backlight off
feature.
4. Select open.
The auto clear/backlight off screen is displayed.
Press [Custom Presets] to return to
Previous screen.
System features Copy features
Storage/Disk
Manager
Open
Time &Date
Auto Power Off
Auto Power save
Auto Clear/ Backlight Off
Attention Tone
Plotter Setup
Loading Stamp Data