Selecting [command mode, Edit the control change, Edit of user definition data – Panasonic WR-DA7 User Manual

Page 173

C h a p t e r 1 1

D A 7 U s e r s ’ G u i d e

1 9

MIDI

Selecting

[COMMAND MODE]

Cursor to the

[COMMAND MODE] area. Select either

[CONTROL CHANGE]. Select the control change number with the
JogDial. In

the message can be edited.

Edit the Control Change

Cursor to the

button, and press the

ENTER button. The [CTRL

CHG NO] area appears.

Cursor to the

[CTRL CHG NO] area, and rotate the JogDial to select the

control change number from 000 – 119.

Edit of User Definition Data

The

[SW STS] area works when using the JogDial. Switching the button

sets transmission data rows separately with the objective

operator and .

For data row input parts, cursor to the data by one byte and select a value
using the

JogDial. At that time, the cursor can move to both the sector where

the data exists and the next sector of the last data.

Selectable data is

00H – F8H, FAH – FFH, K, F, or E.

The

K transmits the value the Knob indicates. The F transmits the value the

Fader indicates, while

E means End of message.

When you have finished editing the

MIDI REMOTE information, cursor to the

button, and press the

ENTER button. If you decide not to keep your

changes, cursor to the

button, and press the

ENTER button.

OFF