Gen tx button, Pre chg button, Ctrl chg button – Panasonic WR-DA7 User Manual

Page 158: Nrpn button, System ex button, Other cmd button, Mtc button

Button

Set the

MIDI output port by pressing the ENTER button. Use the same

with the

. Cursor to

on the

line, and perform the

same step described in

setting.

Cursor to

on the

line, and perform the same step described in

setting. The DA7 sends a message to the selected port, either

[MIDI]

[toPC].

Button

Activate the program change command by pressing the

ENTER button to set

pass-through of receiving, transmitting, and inputting signals on or off.

Button

Activate the control change command by pressing the

ENTER button to set

pass-through of receiving, transmitting, and inputting signals on or off.

Button

Activate this button by pressing the

ENTER button to establish a non-

registered parameter number (NRPN) type command.

Button

This button sets the system exclusive command. Press the

ENTER button to

set pass-through of receiving, transmitting, and inputting signals on or off.

Button

This button sets the commands, other than the program change, control
change, parameter change, MTC, or real-time message commands. Press the
ENTER button to set a pass-through on or off.

Button

This button sets the

MTC (MIDI timecode) input port. Activate a port to

receive the

message that is used to synchronize the DA7 with other

devices. Cursor to the

[PORT] column, and press the ENTER button.

C h a p t e r 1 1

D A 7 U s e r s ’ G u i d e

MIDI

To use the omni

[OM] channel, set the [RAMSA NET] ON in the

[UTILITY>CONFIG] window, and select a serial port in the [MIDI
SETUP] window.