Serial i/o setup] area, Port select] area, To pc button – Panasonic WR-DA7 User Manual

Page 156: Rs button, Baud rate] area

Receive Indicator

The window has receive indicators in the

[taskbar]. A

indicator blinks

when data is received at the

MIDI IN connection, an

indicator blinks

when data is received at the RS 422/485 terminal, and a

indicator

blinks when data is received at the

TO PC terminal.

[SERIAL I/O SETUP] Area

[PORT SELECT] Area

The DA7 has a

TO PC connector port and an RS422/485 serial port on the

Rear Panel. These ports are used for attaching a Mac O/S or Windows O/S
computer platform to the DA7. Only one port can be used at a time. You
must select either

in the

[PORT SELECT] area of the

window. The default setting is

. The

[MIDI SETUP] area reflects back

to this selection(See

[MIDI SETUP] on page 11-3). When using one of the

serial ports you need to assign the

to at least one column of the port

settings in the

[MIDI SETUP] area.

Button

This button selects

TO PC on the Rear Panel for the serial I/O port.

Cursor to the button, and press the

ENTER button. The Mac HSKO 1Mhz

clock is active for this selection.

Button

This button selects RS485 for the serial I/O port. Cursor to the button,
and press

ENTER.

[BAUD RATE] Area

This area offers baud rates for the serial

I/O port. To set a baud rate, cursor to

the

[BAUD RATE] area, select either

[9.6k], [19.2k], [38.4k],

[62.5k] or [125k] using the JogDial, and press the ENTER button. The
initial setting is

[31.25k]. When [31.25k], [62.5k] or [125k] is selected, a

clock is transmitted. Transmission of the 2Mhz clock turns the serial port off
or on. For RS485,

[31.25k] cannot be set; the initial setting for RS485 is

[38.4k].

C h a p t e r 1 1

D A 7 U s e r s ’ G u i d e

MIDI

SERIAL I/O SETUP Area