NewTek TriCaster TC1 (2 RU) - Manual (Page 331)

P a g e | 315
Some more professional cameras offer full manual controls for white balance and/or black level. Use these
as instructed to ensure your camera is providing the correct white and black levels.
If you cannot make source adjustments, or can’t get it quite right by these means alone, you can use the
Brightness and Contrast controls in the Proc Amp for that input to tweak black and white levels. (Of course
it is always best to perform adjustments at the source if possible.)
E.2.2 ADJUSTING COLOR
We’re going to move into color calibration next, but first we can actually use our black and white signals for
some further tests.
V ECTORSCOPE
While we’re still working with black and white levels, we can introduce the Vectorscope , and perform an
initial test of the camera’s colo r balance.
A vectorscope (Figure 379 ) can be likened to the familiar ‘color wheel’ ( Figure 380) which sweeps radially
through the colors of the spectrum – yellow, red, magenta, and so-on, around the arc of a circle. Colors are
more progressively intense (saturated) towards the outside of the circle, while color saturation is zero at its
center.
FIGURE 379 FIGURE 380
As it happens, from the vectorscope point of view, neither black nor white properly have any color saturation.
Thus with the lens cap on (or with a white card filling the viewfinder), the vectorscope should show only a
small fuzzy trace at its center. If the fuzzy dot is off-center horizontally or vertically, this would indicate that
the camera is incorrectly calibrated, actually tinting gray areas.
When the trace is off center, the direction and distance of the offset tells us what sort of tint (and how much)
is represented by the deviation. You may be able to use the color controls at your camera to correct for this
offset, or you can use the
Proc Amp’s U Offset and V Offset controls to do so (as always, source controls are
best). Adjustments to U Offset move the trace left or right, while V Offset changes adjust its vertical position.