beautypg.com

Introduction and setup, Overview, Making connections – NewTek TriCaster TC1 (2 RU) User Manual

Page 318

background image

P a g e | 302

C.2

INTRODUCTION AND SETUP

OVERVIEW

Unlike typical encoders and capture card systems, your NewTek TCMI4KUHD leverages

NewTek’s

NDI-based

IP workflow, supported by leading video software and hardware developers around the globe. This section
will assist you to install and configure your new input device.

MAKING CONNECTIONS

FIGURE 365

1.

Supply

power

and

network connectivity

between

the TCMI4KUHD device and your TriCaster TC Mini

by connecting an Ethernet (Cat 5 or better) cable from the input module

s Ethernet port and one of

the special RJ-45 ports marked NDI 1-4 on TriCaster TC Mini

s rear.

Hint: The input module boots as soon as this connection is made if TriCaster is powered up.

At this point, the NewTek logo will illuminate. (If this does not happen, check your connections and
retry.)

2.

Optional steps:

a.

Connect an HDMI video cable from a suitable video source to the device

s HDMI connector.

b.

If you wish, connect an analog audio source to the 6.35mm stereo audio input.

If you connected a video source in step 2 above, the TCMI4KUHD

module

is ready to send NDI audio and

video to TriCaster. To access and use it, we need to open TriCaster

s Live Desktop.

Hint: In ‘mission’ critical installations

, it is wise to use an uninterruptable power supply (UPS). Likewise,

consider A/C “power conditioning”, especially in sit

uations where loc

al power is unreliable or ‘noisy’.

Surge