NewTek TriCaster TC1 (2 RU) - Manual (Page 248)

P a g e | 232
M/E DELEGATE
Five of the remaining buttons in this group are labeled M/E
DELEGATE . Pressing these buttons assigns all of the other controls
in Stripe 2 to the designated bus (or busses), including the special
PREVIZ bus.
Hint: Add SHIFT to buttons 1-4 to access M/Es numbered 5-8 when
the system supports these.
COPY TO/FROM
At right beside PREVIZ , buttons labeled COPY TO and COPY FROM support the “Send to Previz” and “Copy
from Previz” functions (presented in the Live Desktop via the PREVIZ and associated ‘clipboard’ buttons
located just above T-Bars ).
MEM
When the MEM button is held down, pressing a button between 1 and 9 in the selection rows at left causes
corresponding operation in the MEM bin for the delegated M/E as follows:
• Pressing a button in the DSK/KEY row recalls the corresponding MEM .
• Pressing a button in the PGM/A row stores or updates the corresponding MEM .
• Pressing a button in the PREV/B row clears the corresponding MEM .
COMP
The COMP button operates similarly (to MEM , just discussed). When the COMP button is held down, the first
16 columns in the Switcher or M/E rows at left correspond to the 16 COMPs available for the delegated bus.
• Pressing a button in the DSK/KEY row recalls the corresponding COMP .
• Pressing a button in the PGM/A row stores or updates the corresponding COMP .
• Pressing a button in the PREV/B row clears the corresponding COMP .
23.1.5 CAPTURE GROUP
FIGURE 278
Three buttons labeled REC , STRM , and GRAB are located in this group.
• REC – Pressing this button enables TriCaster's Record feature. As a safety measure, pressing the REC
button when recording is underway does not stop recording. Instead, the SHIFT button flashes to
reminds you that you must hold it down at the same time as pushing REC to end recording.
• STRM (Stream) – Push to enable or disable TriCaster’s live streaming feature.
FIGURE 277