NewTek TriCaster TC1 (2 RU) - Manual (Page 150)

P a g e | 134
1. First, connect the camera’s output t o a Switcher input – see Section 8.1.
2. Next you must configure the control connection to the camera by selecting its type.
o Since the default Connection type in this group is NDI , you can skip this step for an NDI
camera, which eliminates all of the settings you would otherwise need to configure.
FIGURE 162
o For non- NDI sources, use the
Connection menu to choose the
correct PTZ protocol for your
device, and continue to enter
other data as required for that
protocol.
Having performed these steps, you are ready to
expand and use the
PTZ Presets control group in
the same panel, discussed next.
12.1.2 PTZ OPERATIONS
In this group, a set of manual Pan/Tilt, Zoom,
Focus and Iris controls sits just beneath a large
PTZ Preset bin. Drag the mouse on these
controls to make manual adjustments.
Speed controls, including SLOW , MEDIUM and
FAST presets along with a numeric speed
control allow you to modify the speed with
which presets are applied.
FIGURE 163