beautypg.com

1 connection type, Section 16.5 local skype tx callers and mix minus – NewTek TriCaster TC1 (2 RU) User Manual

Page 177

background image

P a g e | 161

16.4.1

CONNECTION TYPE

Naturally, only one connection can be active for a given audio input at any moment. To access
the

Connection

menu, move the cursor into the label of an input, and click the

Configure

(gear)

button that appears just at right. The

Advanced

Audio Configuration

panel will be shown.

The drop-down

Connection

menu at the top of this pane allows you to assign any one of the supported sources

connected to the system to this

Audio Mixer

control column.

FIGURE 200

Local

o

Physical inputs on the syst

em’s backplane

or faceplate listed, usually as

Input #

, but in some

cases as

“Mic” or “Line”.

On some models, local sources support different connection types, as determined by a menu
at right in the same group. This option typically defaults to

Auto-detect

, but depending on

model may include

Line, Mic, or Embedded

(which is the correct setting for audio included

with an SDI or NDI video connection).

o

Dante sources (network audio from systems supporting this protocol from Audinate™).

o

Skype TX Caller 1, 2

(sound from these two special input types, further discussed in the next

sub-heading).

Follow (Video Source)

this is the default selection, and causes the control column to follow the same

numbered video

Switcher

input.

All available NDI audio sources.

Note: Channels 1 and 2 from Master and Aux 1 are always placed on Dante output channels 1-4, respectively.

SECTION 16.5

LOCAL SKYPE TX CALLERS AND MIX MINUS

The default

Connection

option for external

Audio Mixer

inputs is

Follow Video Source

. When an audio input

set this way is assigned to a Local>Skype TX Caller channel, the audio control group is automatically assigned
to govern incoming audio from that remote Skype caller.

FIGURE 199