NewTek TriCaster TC1 (2 RU) - Manual (Page 322)

P a g e | 306
These names are editable, allowing you a convenient way to identify the output of specific units to
downstream NDI-enabled devices and systems.
Hint: The default name includes the unit serial number, which is also provided on a sticker on the chassis to
help you identify a specific device.
A UDIO
FIGURE 372
Just below, you will see the Audio Source menu (Figure 372). It offers two options, labeled Line In and HDMI .
These determine whether device supplies TriCaster with the embedded audio source (digital audio included
with an HDMI video source) or analog audio supplied to its
1/8” line l evel stereo input connector. The nearby
volume control governs the audio output level. The device ’ s nominal audio level is +4dBu.
V ERSION AND U PDATE
FIGURE 373
The control group below Audio settings lists Hardware , Firmware , and NDI Version details, which can be
helpful if you need support or wish to confirm you have the latest firmware update installed.
Hint: The firmware update process is detailed in Error! Reference source not found. , Error! Reference source
not found. .
U TILITIES
FIGURE 374
Completing our discussion of the Basic Settings control group, we find Reset , Reboot and Restore buttons at
the bottom of this pane.
• Reconnect – breaks and re-establishes the connection between the source and TriCaster.
• Reboot – restarts the device (a ‘ warm ’ reboot)
• Reset Factory Settings – has the same effect as pressing the recessed Reset pin near the RJ-45 NDI
connector on the back of the device for a few seconds. This resets all settings to their as-shipped
default states. (On selection, the tally LEDs on the front of the unit progressively cycle to off, then on
again a short while later after defaults have been restored and the unit has rebooted.)