beautypg.com

6 layer select (a/c, b/d) – NewTek TriCaster TC1 (2 RU) User Manual

Page 230

background image

P a g e | 214

To store or update a

COMP

, hold down

CTRL

+

COMP

, then press a button in the selection row below the

display for the desired stripe. To clear a

COMP

, hold down

ALT

+

COMP

, then press a button in the same

selection row.

MACRO

To assign a macro to

any

button, first select the desired macro in the

Macro Configuration

pane in the user

interface. Click a box in the

Triggers

control group at the bottom of the panel, to enable “Listen” mode, then

hold down the

MACRO

button, punch the control surface button you want to use for the macro, and release

the

MACRO

button. (See also Section 22.4.1, NUMBERPAD.)

When the

MACRO

button is held down, the names for any macros assigned to buttons in the (PGM/A/C) row

immediately beneath the selection area displays are shown. Punching the button below a macro name
triggers the corresponding macro.

Hint: To clear an assigned macro from a button, hold down Ctrl with the Macro button, the press the (lit) button
you wish to clear.

SHIFT,

CTRL,

ALT

FIGURE 253

These buttons provide support for extended features and future expansion.

Note: Among other things, CTRL and SHIFT are used in connection with instant replays (see the Replay heading
in Section 22.4.1)
and Buffers (see Section 22.7).

22.3.6

LAYER SELECT (A/C, B/D)

Some TriCaster models let you configure M/Es with effects supporting up to four primary sources (along
with KEY layers). The control surfaces, however, offers just

two

primary source selection rows,

PGM A/C

and

PREV B/D

.

FIGURE 254

In cases where more than two selection rows are required for a given

M/E

, use the

LAYER SELECT

buttons to

delegate the upper or lower selection rows to the layers you wish to control.