Fujitsu Ricoh Fujitsu fi-7900 Image Scanner - Manual (Page 93)

Item Description Setting/Value Factory Default
- : No settings/values
operator panel setting , priority is
given to the operator panel setting.
7: MF Quick
Change Enables you to switch whether or not
to detect multifeed by a push of a
button.
Priority is given to the scanner driver
setting when [1: Disable] is selected.
When [2: Enable (Detect)] or [3:
Enable (Ignore)] is selected, it switches
between detecting/not detecting
multifeed every time the [Eject]
button is pressed. It can be switched
during scanning.
For [2: Enable (Detect)], it detects
multifeed by default and multifeed
detection is performed according to
the scanner driver setting.
For [3: Enable (Ignore)], it does not
detect multifeed by default and
multifeed detection is not performed
regardless of the scanner driver
setting. 1: Disable
2: Enable (Detect)
3: Enable (Ignore) 1: Disable
8: Alarm
Volume Specify whether or not to sound an
alarm when an error such as
multifeed or paper jam occurs.
It can also be configured from the
Software Operation Panel. 1: OFF
2: Low
3: High 1: OFF
9: Stacker
Positioning Adjust the stacker position.
You can set the stacker at certain
heights. 1: Movable
2: Fixed (*1)
10: Hopper
Level Change the hopper level during
standby.
Selecting [1: Manual (Continuous)]
switches the scanner to Manual Feed
mode (Continuous Feed mode). The
hopper level cannot be changed in
Manual Feed mode (Single Feed
mode).
Remove all documents from the
hopper when you configure this item. 1: Manual (Continuous)
2: Upper
3: Middle
4: Lower (*2)
How to Use the Operator Panel
93