Shortening the scanning intervals [pre-pick – Fujitsu Ricoh Fujitsu fi-7900 Image Scanner User Manual
Page 241
Shortening the Scanning Intervals [Pre-Pick]
"Pre-Pick" refers to feeding the document to the starting position for scanning before the next scan.
Enabling [Pre-Pick] shortens the interval between scanning each document.
1
Start up the Software Operation Panel.
Refer to
Starting Up the Software Operation Panel (page 202)
.
2
From the listing on the left, select [Device Setting 2]
→
[Pre-Pick].
3
Specify whether or not to enable pre-pick.
Select [Yes] to enable and [No] to disable Pre-pick.
HINT
●
If you cancel in the middle of scanning while Pre-Pick is enabled, you will have to remove the
pre-picked document, then load the document again.
●
This setting can also be configured in the scanner driver's setup dialog box. Note that
priority is given to the scanner driver setting.
Operational Settings
241