Fujitsu Ricoh Fujitsu fi-7900 Image Scanner - Manual (Page 180)

● To reset the counted value, and continue the scan in Document Count Check mode under the
same document count configurations
Press the [Counter Reset] button on the scanner's operator panel, and then start scanning.
● To clear the Document Count Check mode, and continue the scan
Perform one of the following.
- Press the [Stop] button on the scanner's operator panel, and then start scanning.
- Start scanning directly.
Less document sheets were scanned than the settings configured.
Though you attempted to scan a whole document batch in Document Count Check mode with the
document count pre-configured in Doc Counting mode, less document sheets were scanned.
If there are some sheets to scan, load them on the hopper and click the [Retry] button to continue
the scan.
If there is no sheet to scan, click the [Cancel] button, then check if the number of scanned sheets is
less than the settings configured, and check if there are any sheets not scanned correctly.
To resume the scan, select either of the following ways:
● To continue the scan in Document Count Check mode without resetting the counted value
Load additional documents on the hopper, and then start scanning.
● To reset the counted value, and continue the scan in Document Count Check mode under the
same document count configurations
Press the [Counter Reset] button on the scanner's operator panel, and then start scanning.
● To clear the Document Count Check mode, and continue the scan
Press the [Stop] button on the scanner's operator panel, and then start scanning.
Scanning has been paused by the user.
Scanning has been paused by the user.
To resume scanning, press the [Scan/Pause] button on the scanner's operator panel.
Troubleshooting
180