Fujitsu Ricoh Fujitsu fi-7900 Image Scanner - Manual (Page 117)

Bypassing Multifeed Detection for a Fixed Format
If you attempt to scan a document sheet with a sticky note, receipt, or photo glued on it while the
Multifeed Detection function is enabled, the scanner may falsely judge this as a multifeed error
and discontinue the scanning. To scan these types of documents, the Intelligent Multifeed
Detection Function is available.
There are two modes to this function. In one mode, you can suppress multifeeds forcibly by using
the operator panel on the scanner. In the other mode, you can suppress multifeeds automatically
by letting the scanner memorize the locations and the sizes of attachments.
Intelligent Multifeed Detection Function
The following three modes are available:
Mode Description
Manual mode (Bypass by front panel
button) Checks for any papers attached every time a multifeed
occurs, and continues scanning.
Auto mode 1 (Bypass by combination
of length and position) Used to scan a document stack with paper of the same
size attached in the same location.
Auto mode 2 (Bypass by length) Used to scan a document stack with paper of different
sizes attached in different locations.
ATTENTION
Irregular images may be output when multifeeds occur.
Select a mode with one of the following methods.
● Select a mode in [1: iMFF Setting] on the [Main Menu] of the operator panel.
For details, refer to
How to Use the Main Menu (page 82) .
● Start up the Software Operation Panel, and select a mode.
For details, refer to
Specifying an Area Not to Detect Multifeed [Intelligent Multifeed Function]
(page 272) .
Various Ways to Scan
117