Fujitsu Ricoh Fujitsu fi-7900 Image Scanner - Manual (Page 34)

Setting Up the Stacker
When you perform a scan, the document loaded on the hopper is ejected onto the stacker.
You can stack the documents neatly by using the stacker extension and the stacker side guides as
shown in the procedure below.
You can set the stacker at certain heights.
How to Guide Documents
1 Adjust the stacker extension to the length of the document, and pull up the paper stop.
ATTENTION
● Do not hold the paper stop when you pull out the stacker extension because it may break.
● Make sure that the position of the paper stop is set longer than the document length.
You can align the documents neatly by leaving a small gap between the paper stop and the
documents.
Scanner Overview
34