Fujitsu Ricoh Fujitsu fi-7900 Image Scanner - Manual (Page 111)

Scanning in Continuous Feed Mode
1 Open the hopper if it is closed.
For information on how to open the hopper, refer to
How to Open the Hopper (page 23) .
2 In the [Main Menu] of the operator panel, select [1: Manual (Continuous)] for [10: Hopper Level].
For details, refer to
How to Use the Main Menu (page 82) .
The hopper moves up to the feeding position.
ATTENTION
● Make sure that there is no document left on the hopper.
● Be careful not to get your fingers or any object caught when the hopper moves up.
HINT
You can also set it to [Manual (Continuous)] from the [Hopper Level] screen via shortcut key.
For details, refer to
Setting the Loading Capacity of the Hopper (page 32) .
3 Load documents on the hopper with the front side (scanning side) facing up.
Make sure not to place the documents all the way in.
4 Scan documents with the image scanning application.
For details, refer to the manual or help of the image scanning application.
5 Insert a document until the top edge touches the rollers on the inside.
When more than one sheet is loaded, only insert the document on the top of the stack.
The document is picked, scanned, then ejected onto the stacker.
After the scan, the scanner waits for the next sheet to be fed for the time specified in the
Software Operation Panel.
Various Ways to Scan
111