Fujitsu Ricoh Fujitsu fi-7900 Image Scanner - Manual (Page 88)

5 Press the [Function/Enter] button to confirm.
[Doc Count Check Mode] is displayed on the LCD.
6 Load documents on the hopper, and scan them with the image scanning application.
For details, refer to the manual or help of the image scanning application.
Depending on the number of sheets scanned, it will be displayed as follows:
Sheets Display Description
75 sheets Since the count has been set to 100 in step 4 , it
is -25 sheets. [-] appears in the top right and
"25" is displayed for [Count].
If you load additional documents at this point,
you can scan up to 25 sheets.
100 sheets Since the count has been set to 100 in step 4 , it
is +/- 0. [=] appears in the top right and "0" is
displayed for [Count].
110 sheets Since the count has been set to 100 in step 4 , it
is +10 sheets. [+] appears in the top right and
"0" is indicated for [Count].
Scanning stops once 100 sheets have been
scanned.
ATTENTION
● Documents may not be counted correctly if a multifeed occurs during scanning.
● In the following cases, the scanning returns to normal from Doc Count Check mode:
- When you only scan the specified pages
- When you scan using a Job Separator
HINT
● When you press the [Counter Reset] button, the screen returns to [Doc Count Check Mode]
in step
5 .
● When you press the [Stop] button, it exits [Doc Count Check Mode] and returns to the
[Ready] screen.
How to Use the Operator Panel
88