Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 99)

83 CHAPTER 6
Mapping
Mapping a Hardy Control-Link Network to
a ControlNet/DeviceNet/Profibus Network
FIG. 6-55 HARDY CONTROL-LINK NETWORK CONNECTED TO A CONTROLNET/DEVICENET/PROFIBUS
NETWORK
The Hardy HI 3000 Series of controllers are designed to save
you money. To connect a Hardy Control-Link Network to a
ControlNet/DeviceNet/Profibus Network simply purchase
one of the Hardy HI 3000 Series Network Interface Option
Cards and install it in the instrument that you want to directly
connect to the other network. You can map to this instrument
from all the other instruments on the Hardy Control-Link
Network, rather than buy a separate network card for each
instrument. (See Fig. 6-55)
Step 1. Determine into which Instrument you want to
install the Network option card.
Step 2. Install the network card. See the HI 3000 Installa-
tion and Operation manual, Cabling and Installation
Section.
Step 3. Connect the network cables from the designated HI
3000 Series Instrument and begin mapping to that
instrument from either the Hardy Control-Link Net-
work or the ControlNet/DeviceNet/Profibus Net-
work.