Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 108)

HI-3010 Filler/Dispenser/IBC 92
Service Manual
FIG. 7-32 OVERDISPENSE ALARM
• OVERDISPENSE ALARM, press the
Clear button to clear the alarm. The
Accept the Dispense display appears. (See
Fig. 7-33) At this time you can:
1. Accept the dispense by pressing the
START button.
2. Physically remove some of the mate-
rial until it meets the target window
requirements and then press the
START button.
3. The instrument returns to the Waiting
ON display, repeats the motion check,
autotares and/or checks the OK to
Dispense processes and begins dis-
pense cycle number 2. (See Fig. 7-33)
FIG. 7-33 ACCEPT DISPENSE DISPLAY
• UNDERDISPENSE ALARM, press the
Clear button to clear the alarm, the Accept
the Dispense display appears. At this time
you can:
1.
Accept the dispense by pressing the
START button.
2. Physically add some of the material
until it meets the target window
requirements and then press the
START button.
3. The instrument returns to the Waiting
On Display, repeats the motion check,
autotares and/or checks the OK to
Dispense processes and begins dis-
pense cycle number 2
4. The instrument checks to see if the
gate of the vessel opens.
IBC/Dispense Alarms
Change IBC Alarm
- - - - - ALARM CONDITION - - - - -
• If there is still no motion. An alarm telling
you to Change IBC appears. (See Fig. 7-
34)
FIG. 7-34 CHANGE IBC ALARM
Jog Alarms
Jog Gate Did Not Open Alarm
- - - - - ALARM CONDITION - - - - -
• The instrument checks to see if the gate of
the vessel opens. If the gate DID NOT
open a JOG GATE DID NOT OPEN
ALARM appears on the display and the
Filler/Dispenser is placed in a hold state.
(See Fig. 7-35)
FIG. 7-35 JOG GATE DID NOT OPEN ALARM
1. Check to see why the gate did not
open. Correct the problem. Press on
the Clear button to clear the alarm.
(See Fig. 7-36)
FIG. 7-36 TO JOG AGAIN PRESS START DISPLAY