Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 37)

21 CHAPTER 4
Configuration
CHAPTER 4: CONFIGURATION
About Chapter 4
Chapter 4 contains step-by-step instructions for configuring
the Hardy Instruments, HI 3010 Filler/Dispenser/IBC. The
procedures include complete instructions for configuring the
Filler/Dispenser from the Front Panel, DeviceNet and Web
Browser). We highly recommend reading the procedures
before configuring the Filler/Dispenser. For information on
network setup, optional cards, and Email, see the HI 3000
Series Operation and Installation Manual.
Being familiar with the operating procedures insures that the
Filler/Dispenser will provide trouble free service. For the
best performance of the HI 3010 Filler/Dispenser, any
instructions that are not contained in this manual (either
implicit or explicit) are not recommended. It is important to
note that the HI 3000 Series standard products do not require
any jumper or dip switch settings. Some of the communica-
tion option cards do have jumper settings, however.
Getting Started
Before configuring the Hardy HI 3010 Filler/Dispenser,
check to make sure the following procedures have been per-
formed.
• Panel Mount and Blind Mount units properly
installed. (See chapter 3 - Installation)
• Power and Load Point cables properly installed
• Communication cables properly installed.
• All connectors securely fastened.
All the functions of the Filler/Dispenser operate the
same no matter what the interface. First let’s get
familiar with configuring the Filler/Dispenser from
the front panel of the instrument. (See Fig. 4-1)
Help Dialog
About the Help Dialog
As you move through the setup/configuration menus you
may on occasion need assistance. If you need help, do the
following:
Step 1. Use the up and down arrows and move the cursor in
front of the Menu Item you want help on.
Step 2. Press the Help button either on the front Panel and a
Help Dialog appears. The Help Dialog tells you
what the Menu Item is used for or other descriptive
information to help you enter the right parameters
for the current menu item.
Step 3. Push the clear button again to return to the current
menu.
Configuring the Filler/Dispenser from the
Front Panel
FIG. 4-1 FRONT PANEL
Front Panel Display
The Front Panel Display is a 4 line x 20 Alphanumeric char-
acter LCD. The screen displays all the menus for Configur-
ing, Calibrating and Operating the HI 3010 Filler/Dispenser.
Button Functions
Start Button
The Stop button if pressed once will pause the filling or dis-
pensing process. If the Stop Button is pressed twice it stops
the process and puts the Filler/Dispenser in a standby mode
which it will maintain until another button is pressed.
Help Button
The Help Button initiates the Help Dialog which displays a
Help message for the current Menu Item (the Menu Item in
front of the cursor) that is displayed.
Manual Button
Enables you to enter the manual mode of operation for the
following:
• Tare Scale - Press Clear button to tare the instrument.
• Discharge - Press the Start button to start a discharge.
• Refill - Press the Start button to Start a refill.
• Auxiliary Device - Press the Start button to start an
Auxiliary device.
• Fast Fill/Dispense - Press the Start button to start the
Fast Fill.
• Fill/Dispense - Press the Start button to start slow fill.