IAI America CON-PG - Manual (Page 50)

44
5. Operation of CON Controllers
(1) Basic operation
[Data entry on the position data table screen]
You can set the target position, speed, acceleration and deceleration in the position data table.
Touch [ ] and [ ] to display the table showing the desired position data number.
Or, touch [Specify No] and set the desired position data number to display the table.
Touch a value in the target position or other
field of the desired position data number.
When the numeric keypad appears, key in the
desired value and touch [ENT], and the value
will be entered.
Touching Axis No. switches to the axis
selection screen.
Touching [All Clear] clears all position data.
(Example of entry: P. 56)
Touch.
[Important]
Do not touch [ ] key or [ ] key too fast to switch the windows.
‘0’ is occasionally shown to the data values that are already registered.
The data is not lost even though ‘0’ is displayed. Touch [ ] key and [ ] key to switch the window and
come back, and you will find the data showing the right values.
↑ ↓
↓ ↑
↑ ↓