IAI America CON-PG - Manual (Page 29)

23
5. Operation of CON Controllers
PCON
ACON
5.3 Changing Operating Axis
If multiple controllers are connected to the communication line, the axis selection screen appears.
This screen also appears when [Change Operate Axis] is touched on the Menu 2 screen.
If only one controller is connected, you need not select an axis.
Select and touch the axis you want to connect the touch-
panel teaching pendant to.
This screen appears when the enable function parameter of
the controller, other than CON-PT, is set to [Disable].
Select and touch [Yes] (Enable) or [No] (Disable) for the
enable function.
Connection with the selected controller axis starts.
When connection with the controller is established, the Menu
1 screen appears.
5.4