IAI America CON-PG - Manual (Page 186)

180
7. Operation of MEC Controllers
2) Manual axis operation (jogging/inching) (Using , to
jog/inch the actuator to the target position, and then loading the achieved position (current
position) as the end point or start point)
An example of stopping at 2 points is explained.
How to load the current position of 80.0 m as the start point is explained.
No. Operation Screen Remarks
1 Touch [Pos. Edit] on the MEC
menu screen.
2 If the password is not “0000,” the
password entry screen appears.
Enter the password. A desired position setting
password can be set in the
“position data edit password” field
of the parameter edit screen.
3 Set the position relating to the
start point, acceleration, and
deceleration.
Touch [Starting Point].
Touch [Menu] to return to the MEC
menu screen.
4 Touch [Manu Move]. Touch [Menu] to return to the
position setting screen
* If home return is not yet
complete, perform home return
first.
5 If the motor power (servo) is
currently off, touch [Servo ON] to
turn on the motor power (servo)
6
Use to
move the slider or rod to the target
position of 80.0 mm.
x Jogging
Touch any of ,
and the axis will move and
continue moving.
x Inching
Touch any of ,
and the axis will move by the
distance corresponding to the
button you have touched.
䢺䢲䢰䢲䢲