IAI America CON-PG - Manual (Page 168)

162
7. Operation of MEC Controllers
7.3 Initial Setting
When the power is turned on for the first time after the delivery of the controller, the initial setting
screen will appear.
x Select [Yes], and the display will change to the initial setting screen where you can set the
operation pattern.
x Select [No], and the factory set operation pattern, or specifically the 2-point stopping operation
mode, will remain effective.
The display will switch to the position setting screen.
Factory settings
x Operation pattern: Stopping at 2
points
[Refer to 7.5, “Initial Setting.”] [Refer to 7.6, “Position Setting.”]
7.4