Panasonic MINAS E-series - Manual (Page 53)

53
[Preparations]
Preparations
SHIFT
SHIFT
• The blinking decimal point is shifted by pressing .
(Right side of the decimal point: Signal selection mode)
(Left side of the decimal point: Input/output selection mode)
• Signal No. can also be changed with input/output mode as follows:
Display of input/output signal status
The status of control input/output signal connected with connector CN X5 is displayed.
Make use of this display to check the quality of wiring and for other purposes.
•••••••• Input signal
•••••••• Output signal
(No. of the lowest
place of input signal)
(No. of the highest
place of input signal)
(No. of the lowest
place of output signal)
(No. of the highest
place of output signal)
Signal No. (hexadecimal number 0 - 1F)
•••••• Active
(The signal is active.)
•••••• Inactive
(The signal is inactive.)
Select no. of the signal to be monitored by pressing
and .
Transition by
pressing .